How to Use Dritz Iron

Transcription

How to Use Dritz Iron
Additional Product Instructions & Illustrations
Dritz® Home: Iron-On Shirring Tape (item #44501)
The parts:
Iron-on Adhesive
Shirring Cords
This side is placed
against the fabric.
This side faces away from fabric.
What is Iron-On Shirring Tape?
It is an iron-on tape used to gather the top edge of a curtain panel. It
is also great for other craft and home decorating projects where evenly
shirred edges are required such as a table skirt or window shade.
How do you use Iron-On Shirring Tape?
1. Planning and Preparation: Cut fabric panels 1-1/2 to 2 times desired
finished width. Finish top, side and bottom hems of curtain panel. Cut tape
about 6” longer than finished panel width.
2. Placing the Tape: Center tape, adhesive side down, on wrong side of panel,
near the top edge. Pin to hold tape in place. Pull cords out of tape at edges
of the panel. Cut off excess tape; do not cut cords.
3. Fuse Tape: With dry iron on “Wool” setting, press tape for 10 to 15 seconds
in an area. Continue along length of tape until it is completely fused.
4. Shirr: At one end, knot cord ends together. Pull cords from opposite end
to shirr the tape. Knot cords when panel is gathered to desired width.
Adjust gathers evenly.
TIP: For tighter pleats, lightly steam a section of tape before pulling cords.
Be careful not to steam too much or tape will pull off the fabric.
Step 1
Side
hems
Top hem
Wrong side
of curtain
Step 2
Step 4
Step 3
Bottom hem
5. Attach to rod with clip rings or pin-on hooks.
© Prym Consumer USA