t800 cpu chip build instructions

Ultra realistic
T-800 CPU chip Build
1. The base of the chip is cut
2. Select a piece to use
from a junk motherboard.
larger than needed.
3.To cut out the part I used a
band saw but a hand saw or
even good scissors work too.
5. Shape the piece to match
the correct size.
4. Remove any high spots on
both side of the board piece.
6. I used a fine needle file the
cut in the notch at the end.
Created By Jamie Staff, Available for download at jazcreations.com.au
7. The chip I used is a bc546
8. The chip back is sanded flat
transistor about 20 cents each.
and the terminals are cut of,
9. 30 chips needed, the other
10. I used a 5 min araldite
parts are also cut off the board.
to glue on the small parts.
12. The finished CPU Chip
11. Small pliers or tweezers
are useful for the placement
of the small bits.
Created By Jamie Staff, Available for download at jazcreations.com.au
Terminator 2
reference photo’s
Terminator 2 special addition.
The resetting the chip scene.
Time index 1:11:30 to 1:14:38 this
sequence features the oversized chip and
port, the larger size was used to aid in
getting a clearer close up shot.
Terminator 2 special addition. The Miles Dyson research scene. Time index 0:27:05 to
0:27:20 this sequence features the “artifact” chip and is based on the smaller scale.
The picture on the right gives a better
representation of the size difference while
the pictured chips are not screen used, it
does show a good example of the
scale comparison.
Created By Jamie Staff, Available for download at jazcreations.com.au
Terminator T-800
CPU chip
Basic size/scale 1:1 layout
7 mm
17 mm
4x4 mm
44 mm
3x17 mm
10 mm
11 mm
Possible Display ID Plate
CPU BRAIN CHIP
STOCK
SERIAL
RATING
PART
SERIES
READ TYPE
MODEL
SERIAL NO:
SKYNET CYBERNETIC RESEARCH DIVISION
LOS ANGELES CALIFORIA 90001
Created By Jamie Staff, Available for download at jazcreations.com.au