SATA to 44-Pin IDE Converter User Guide

T E C H N O L O G I E S
User Guide
SATA to 44-Pin
IDE Converter
(ADSAIDE44)
www.addonics.com
Technical Support
If you need any assistance to get your unit functioning properly, please
have your product information ready and contact Addonics Technical
Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
Overview
Front View
1. 44-pin IDE Connector
2. SATA Power and Data Connector
3. Master, Slave & Cable Select
Jumpers
4. Pin 1 Marker
1
2
Back View
3
4
Jumper Settings
Master
Slave
Cable Select
NOTE: To set the SATA hard drive as a Master Device when connected to an IDE channel,
do not install a jumper. As a Slave Device short the middle pins.
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Installation
1. 15-pin SATA Power & 7-pin Data
Connector
Step 1. Locate the SATA connector
of your 2.5” SATA drive.
1
Step 2. Connect the converter
board to the SATA connector of the
hard drive.
Step 3. (Optional) Connect the IDE
ribbon cable to the 44-pin connector
on the converter. The red edge of
the ribbon cable needs to line up to
pin 1 marker of the 44-pin connector. The other end of the ribbon
cable will be connected to your
motherboard’s 44-pin IDE channel.
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
CONTACT US
www.addonics.com
Phone:
Fax:
Email:
408-573-8580
408-573-8588
http://www.addonics.com/sales/query/