Delivers Superb Results for all Stone Projects.

Delivers Superb Results for
a l l S t o n e P ro j e c t s .
Essroc’s STONE-HOLD
cement, when used in the
recommended formulations, is
an excellent choice for today’s
stone construction applications. It
provides optimal bond strength while
maintaining excellent workability. This
proprietary formulation also improves
resistance to cracking during freeze/thaw
cycles. Additional features include:
• Excellent Durability.
• Superior Strength and Adhesion.
• Consistent Workability.
• Compatible with Natural and Manufactured
Stone for Exterior or Interior Applications.
Superior Adhesion
& Strength
Using the following recommended formulations will reduce
shrinkage cracks, and improve overall performance.
Mortar for Wall and Stone Surface
Parts by Volume
Mortar
for
Stonework
STONE-HOLD Cement
Masonry Sand
1
2 1/4
Grout Proportions for Stone Work
Parts by Volume
Mortar
for
Grouting
STONE-HOLD or
Flamingo Brixment
Colored Cement - Type N
Masonry
Sand
1
3
PerformanceProven Durability
S T O N E - H O L D C e m e n t f o r S t o n e Wo r k
Av a i l a b l e I n Yo u r R e g i o n .
Why settle for less than the ideal? Ensure the long-term strength and esthetic value of your
project with Essroc STONE-HOLD cement formulated for stonework applications. If
unavailable at your supplier, contact the Customer Service Center in your region.
For more information call: 1-800-523-9238
Important Note: STONE-HOLD cement for stone work should be used in accordance with
local building codes. Consult all instructions and requirements provided by the stone
manufacturer prior to installation.
INSTRUCTIONS:
MIXING
Mix mortar thoroughly for a
minimum of 5 minutes. Use only
clean potable water.
S T O N E I N S TA L L AT I O N
• Prepare surfaces properly.
Consult stone
manufacturer’s
instructions.
• Apply 1/2 inch of mortar
over CMU wall, sheathing
or rigid insulation.
(See diagram below)
• Apply 3/4 inch of mortar to
the back of each stone unit.
Cover back completely.
Sheathing
Moisture
Resistant
Barrier
Wire Lath
• Press coated unit firmly
on wall.
• Some mortar should be
squeezed out around the
stones’ edges.
• Ensure complete coverage
between vertical surface and
back surface
of the stone.
FINISHING JOINTS
• Use a grout bag to fill in
joints.
• Avoid smearing on stone.
Accidental smears should be
removed only when dry.
Use a dry brush.
• Finish joints when thumbprint dry with a metal or
brush tool.
Scratch
Coat
Stones
How Much Cement Will You Need?
Based on application experience, for every 100 square feet
of stone surface, you will need an estimated
3 bags of STONE-HOLD cement for Stonework.
www.essroc.com
www.ColorPlan.com
For more information, MSDSs, and technical data sheets,
visit www.essroc.com.