PORTAGE sTOnE™

P O R T A G E s to n e ™
Pattern
Installation
Portage Stone allows for fluid installation
due to its ease of placement. Each unit
can be turned in any direction to allow a
random look.
To cut a slab in two, use a cold chisel (striking
along the center line towards the outside on both
sides of the slab), or a wet dry diamond saw.
Recommended Tools & Materials:
•
R ecommended safety gear
(steel-toed boots, gloves &
eye protection)
•
Hard toothed rake
•
1" screed rails
•
4' hand level or transit level
•
String line and stakes
•
Hammer
•
Chalk line
B a s ic i n s ta l l atio n
Refer to the installation guide for a description of how to prepare the foundation beforehand.
I n s ta l l atio n o f a patio or a s i d e w a l k — W I T H O U T C U T T I N G
Step 1
Step 2
Step 3
Begin by laying 3 slabs at the center
of the surface to be covered.
Add more sets of 3 slabs to fill in the
surface to be covered.
Complete the balance of the surface
to be covered with single slabs for
the final result.
I n s ta l l atio n o f a patio or a s i d e w a l k — W I T H C U T T I N G
Step 1
Step 2
Begin by laying half a slab at the
left-hand side.
Continue by fitting more sets of
3 slabs (cloverleafs) against the
others. The cutting will be done
when the entire surface has
been covered.
Step 3
Keep the cut-off pieces of slab to
fill in the empty spaces. For some
lengths and widths, the loss can
be limited.
PORT01-A