1 Step 1. Materials Required 1275 Danner Dr. Aurora, OH 44202

Transcription

1 Step 1. Materials Required 1275 Danner Dr. Aurora, OH 44202
1275 Danner Dr. Aurora, OH 44202
Tel: 1-800-626-7801
Fax: 330-562-1999
www.vpi.us
How to Assemble a Category 6 Shielded Field Assembly RJ45 Plug
Step
1
Step 1. After the outer sheath
insulation is stripped, wrap the
drain wire around the jacket.
Untwist the pairs to within 1/8”
of the jacket and arrange the
wires according to TIA/EIA
568A or 568B standards.
Materials Required




Step
2
Step
3
Step
4
Step 2. Flatten and align the
wires appropriately to be seated
within the plug.
Step 3. Insert prepared cable
into loading bar by pushing
the bottom wires through the
appropriate holes (ref: Wiring
Diagram) and pressing down on
the top row of cables to be seated
into their appropriate slots. Trim
the excess wires.
Step 4. Finally align the plug
with the appropriate slots of the
IDC and press down firmly (with
either using your fingers or a
Parallel Crimp Tool) until you
hear it snap together. Apply the
strain relief cover over top of the
cable and into the designated slots
located on the sides of the IDC.
Step 5. Test the cable using a cable tester to check for shorts,
opens and miswires.

CAT6 Cable
CAT6 Plug
•
6-PLG-SH-FA
CAT6 Stripper
Parallel Crimp Tool
•
CRIMP-PLG-FA
•
CRIMP-PLG-FA-LC
CAT6 Cable Tester
Wiring Diagram
Top
(slots)
Bottom
(holes)
7
4
8
5
3
2
6
1
TIA/EIA 568A
7
4
8
5
3
2
6
1
TIA/EIA 568B