TIC [U] Tire Inspection Center

TIC [U]
Tire Inspection Center
Freely configurable test sequence
High repeat accuracy
NC-controlled movement sequences
Time-saving due to conicity correction
at system level
Energy-saving due to feedback of
electricity and dispensing with the
use of a hydraulic unit
Space-saving due to compact design
Easy to maintain
Good accessibility of the machine
and all components
Transport of the undismantled
machine allows for fast startup
Load wheel drives to tire
TIC [U]
Tire Inspection Center
Uniformity
Machine data
Picture below:
TIC as a module
in a complete test line
Dimensions (W x D x H)
Weight
Rim diameter
Machine rim width range
Load wheel
Supplies required
Electrical
Pneumatic
1725 mm x 2800 mm x 2500 mm
3100 kg
13" to 25"
6.5"
Ø 854 mm x 16" width
Tire data
Min
Max
Bead diameter
Bead width
Outside diameter
Tire cross section
Tire weight
13"
3.5"
476 mm
127 mm
5 kg
25"
14"
950 mm
400 mm
50 kg
3 ph, 400 V, 50 Hz, 35 A
600 kPa
Technical specifications for uniformity
Measurement range lateral
Measurement range radial
Test pressure
Measurement speed
Repeat accuracy (s)* radial force & harmonics
Repeat accuracy (s)* lateral force & harmonics
Repeat accuracy (s)* conicity
Repeat accuracy (s)* test load
Repeat accuracy (s)* test pressure
Repeat accuracy (s)* test pressure fluctuation
Cycle time**
(Two directions of rotation, two settling times
[2 s and after changing direction 4 s], no rim width
adjustment)
9 kN
18 kN
Max 500 kPa
60 min-1 – 90 min-1
≤2N
≤2N
≤2N
≤ 20 N
≤ 0.1 kPa
≤ 0.2 kPa
20 s
* (s) = Average standard deviation
** Measurement conditions: 10 x 10 test, verifiably tested master tires 16" (205/55 R16) with stable values, spring stiffness ≤ 180 daN/cm, max radial uniformity 100 N,
test pressure 200 kPa, rim contour as per WDK 109, tire mounting lubricant Dr. Schnell C12
TIC [U]
Tire Inspection Center
Uniformity
Seichter GmbH | Esperantostr. 8 | 30519 Hannover | Germany | Phone: +49 511 87597-0 | Fax: +49 511 87597-39 | E-mail: [email protected] | www.seichter.com