Semco® Click-Patch Kit™ Instruction Sheet

Transcription

Semco® Click-Patch Kit™ Instruction Sheet
T E C H N I C A L D ATA
I n structio n Sheet f o r Sem c o ® Cl i c k- Pat c h K it™
S up p lied with Ap p ro ved Fuel Tank Seal an t
Complete package with
Mil-S-8802 sealant, mixing plate,
solvent, cleaning pad and surface
abrader, and Click-Patch™.
Use surface abrader to clean
surface to bare metal.
Use surface abrader to lightly
abrade surface of patch.
Use solvent cleaning pad to clean
surface to be repaired.
Use solvent cleaning pad to clean
patch.
Cut edge of bag containing light
colored material.
Dispense all material onto mixing
plate.
Cut edge of bag containing dark
colored material.
Dispense all material onto mixing
plate.
W h e r e S m a r t S o l u t i o n s Ta k e F l i g h t ®
I n structio n Sheet f o r Sem c o ® Cl i c k- Pat c h K it™
S u pp lied with Ap p ro ved Fuel Tank Seal ant
Mix thoroughly until material
becomes one color.
Apply a small amount of material to
the center of the patch.
Remove protective green tape.
Center patch over leak and press
firmly on outer edges of the
Click-Patch™ cover.
Press firmly on center of
Click-Patch™ cover to activate
click mechanism, forcing patch and
material to the repair area.
When mixing stick cannot be
removed from material, the ClickPatch™ cover can be removed.
Remove cover by grasping the edge
of the cover and peeling up.
The repair is now complete. Excess
material can be trimmed before
total cure occurs and then surface
painted, if required.
Semco is a trademark of PRC-DeSoto International, Inc., registered with the U.S. Patent Office.
Click-Patch is a trademark of Physical Systems, Inc.
All recommendations, statements, and technical data contained herein are based on tests we believe to
be reliable and correct, but accuracy and completeness of said tests are not guaranteed and are not to be
construed as a warranty, either expressed or implied. User shall rely on his own information and tests to
determine suitability of the product for the intended use and assumes all risks and liability resulting from
his use of the product. Seller’s and manufacturer’s sole responsibility shall be to replace that portion of the
product of this manufacturer which proves to be defective. Neither seller nor manufacturer shall be liable
to the buyer or any third person for any injury, loss, or damage directly or indirectly resulting from use of,
or inability to use, the product. Recommendations or statements other than those contained in a written
agreement signed by an officer of the manufacturer shall not be binding upon the manufacturer or seller.
Printed in the U.S.A
PRC-DeSoto International, Inc.
12780 San Fernando Road
Sylmar, CA 91342
Telephone (818) 362-6711
Toll Free (800) AEROMIX
www.semcopackaging.com
Issue Date: 12/10
Supersedes: 05/00
Lit: 0642