BannerMASTER Bracket Installation Instructions 1 2 3 4 5 6 7 8

Transcription

BannerMASTER Bracket Installation Instructions 1 2 3 4 5 6 7 8
BannerMASTER Bracket Installation Instructions
5
1
Insert stove bolt from behind through elongated
slot and hold in place.
Install second banding strap on bottom of back plate
and tighten down.
6
2
Slide banner onto bracket
arm at top and loop wire or
electric ties through grommets
and around lightpole to insure
banner will not slide off of arm.
Note: Be sure end of ties are
not touching banner.
Place punched plastic spacer over stove bolt on
face and slide all the way down. Place second
stove bolt from behind through elongated hole
and through plastic spacer as shown.
7
Pull banner down to find approximately where the back
plate for the bottom bracket should be placed. Try to
center back plate so pocket will fall in about the middle
for maximum adjustability up and down.
3
8
Repeat steps 1 through 6 for bottom plate.
Place bracket plate at desired height on lightpole
and duct tape to pole to hold in place.
4
Wrap the first steel band around back plate at top and tighten down.
Remove duct tape and place rod plate over stove bolts.
Special Note: Bracket has a cantilever system built into rod plates. Be
sure the arrow on the plate is always pointing at the banner.
For larger banners (over 30” x 60” or when hanging two banners per
pole) we advise that you use two stainless steel straps at outside end
of back plates, one strap at other end of back plates.