TCC Ops Manual for Print.indd

Transcription

TCC Ops Manual for Print.indd
User Manual
ADAPTER
Kitchen Center by TCC, LLC
315 West La Cadena,
Riverside, CA 92501
Tel: 888-822-5824
www.TCCkitchencenter.com
Copyright Kitchen Center by TCC 2007
s
ADAPTER
KCADP-A/KCADP-B
UNPACKING/SETUP
RUBBER GASKET
RING
ADAPTER
SHIM
When using electrical appliances, basic safety precautions should be
followed, including the following.
·
·
·
·
·
·
·
·
·
OWNER'S MANUAL
IMPORTANT SAFEGUARDS
·
Read all instructions.
Close supervision is necessary when any appliance is used by or
near children.
Be sure the Power Base is turned off before putting on or taking off
the Adapter.
Check the Adapter for presence of foreign objects before use.
Avoid contacting moving parts.
Always use after the Adapter has been secured in place.
Do not operate appliance after it has been dropped or
damaged in any manner.
Keep hands, hair and clothing well away from moving parts.
Flashing light indicates ready to operate. Avoid any contact
with blades or moveable parts
Adapter is for household use only.
SAVE THESE INSTRUCTIONS
OTHER ITEMS NEEDED
Thank you for your purchase of the Kitchen Center Adapter.
This adapter allows you to use new Kitchen Center
attachments on old Nutone Food Center units. Before you
try it out, take a few moments to read this Owners Manual
and familiarize yourself with the function of the Kitchen
Center Adapter.
Please see www.TccKitchenCenter.com for more attachments
and information.
GLASS BLENDER
KC-GBL
STAINLESS BLENDER
KC-SSBL
HOW TO USE
*KCADP-A is for the Glass Blender.
*KCADP-B is for the Stainless Blender.
Both are similar in operation and use.
NOTE FOR BOTH BLENDERS
If the bottom of blade assembly in jar is plastic (fig 1b), the shim
inside the adapter is not needed and should be removed before use.
If the bottom of blade assembly in jar is metal (fig 1a), the shim
needs to be in place at the bottom of the adapter as shown.
BOTTOM OF BLADE ASSEMBLY
fig 1a
METAL
fig 1b
PLASTIC
Shim is not needed
Set the blade assembly in the bottom of the adapter,
make sure rubber gasket seal is in place on top of blade
assembly, so fluid doesnt spill.
Rubber Gasket Ring sits on top of the ring of blade assembly
After shim and gasket ring are in place in the Adapter, set Blender on
Adapter and screw clockwise until tight, then place on Food Center
as shown below.

Similar documents