Visio-Open Flame Box.vsd
Transcription
Visio-Open Flame Box.vsd
Model and Diagrams © Dennis Walker Open out Repeat last two steps on right side and open out entirely Page 1 of 4 Model and Diagrams © Dennis Walker Starting point for Double Flame Make 3D A Tuck this under the edge underneath. B During assembly, B goes OVER A (i.e. A goes inside B). Note that the far edge of B can be used to hold down the folds under the flame/petal A B The white part of the A flame/petal goes under the coloured part of the B flame/petal. Page 2 of 4 Variation of Open Flame. Uses same body. Model and Diagrams © Dennis Walker Fold Open Flame Lid up to and including the diagram marked Fold and unfold. Top Layer only Make 3D Separate layers (pull paper from behind) Lift Top Layer to form first flame/ petal using existing creases. Allow it to curve. Squash the flap. The valley fold indicated lies along the centre line underneath. Fold flap under Soft petal fold X5 Assembly similar to Open Flame Page 3 of 4 Model and Diagrams © Dennis Walker (Note: Unconfirmed suspicion that this may be an independent discovery of a base by Tomoko Fuse) Add the pinch marks shown One unit complete Page 4 of 4