Document 6445598

Transcription

Document 6445598
Kids’ Adirondack Picnic Table
Thank you for purchasing our Kids’ Adirondack Picnic Table. Assembly of this
product requires a standard Phillips and flat head screwdriver as well as a pair of pliers.
We have found it helpful to have a second person present in at least one step of the
assembly.
0T693072702
PARTS
STEP 1
Read through these instructions thoroughly before
beginning assembly. We have found this to be of
great value when first assembling this product.
STEP 2
Remove all parts and hardware from packing
material. Wooden pieces should be placed on a nonabrasive surface (like the carton or carpet) to prevent
damage to the finish.
STEP 3
Identify all parts using diagram at right
STEP 4
Identify and count hardware using diagram at right.
Assembly of this product requires a standard Phillips
and a flat screwdriver and a pair of pliers. We have
found it helpful to have a second person present
in at least one step of the assembly.
WARNING:
ADULT ASSEMBLY REQUIRED.
ASSEMBLY KIT CONTAINS SMALL PARTS
THAT PRESENT CHOKING HAZARDS FOR
CHILDREN.
ASSEMBLY KIT CONTAINS PARTS WITH
SHARP POINTS AND EDGES.
Washer – quantity 16
Bolt – quantity 16
Cap Nut – quantity 16
Screw – quantity 4
STEP 5
Stand seat assembly on its side. Position legs as
shown on outside of seat assembly and install bolts
through both parts. Start washer and then a cap nut
on each bolt until hand tight only. Bolts will be
tightened further in Step 8.
1 of 3
0T693072702
STEP 6
Place table in an upright position and lower table top
into position as shown here. Install the remaining 8
bolts through the legs and into the tabletop. Now
add a washer and a cap nut to each bolt and hand
tighten only. Bolts will be tightened further in Step
8.
STEP 7
Turn table upside down and fit the two braces into
the four slots. Adjust the bottoms of the braces so
that all four fit as flat as possible into the bottoms of
the slots. Make sure that they fit correctly. From the
outside of the seat assembly, install a 1” wood screw
into each brace and tighten.
STEP 8
Turn table upright and install two 1” wood screws
through the top of the table and into the brace until
tight.
Be sure the braces are fitting completely inside the
slots underneath the tabletop.
Gently rock the table back and forth on a flat surface
to be certain that all four legs are touching the
surface so the table will sit flat.
Using a screwdriver on the bolt head and pliers (or
an adjustable, or a 7:16” wrench) on the cap nut,
completely tighten all bolts until the bolt head
begins to be pulled slightly into the wood.
2 of 3
0T693072702
CARE
This Kid’s Adirondack Picnic Table is painted with
exterior house paint and the finish is designed to
provide long lasting protection when exposed to the
harshness of weather. But no matter how durable,
painted wooden furniture should not be left outdoors
continually. It is best to store it inside when not in
use. Even in mild conditions, painted wood
furniture left outdoors will eventually fade and show
the effects of exposure to weather.
To clean your painted furniture, use a mild detergent
such as dishwashing liquid and a soft cloth. Never
use any type of abrasive cleanser.
3 of 3
www.llbean.com
Product Support 1 800 341 4341
0T693072702