SB-GM-C7CP1/10TW3

Transcription

SB-GM-C7CP1/10TW3
SB-GM-C7CP1/10TW3 INSTR_SKU# 011384
If you choose to perform the installation yourself, it is absolutely vital
that the Stealthbox® be properly mounted to the vehicle according to
these instructions. Failure to mount the enclosure properly presents two
problems:
1) T he sub-bass performance will suffer due to the movement of the
enclosure caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a
collision or sudden deceleration.
I N S TA L L AT I O N G U I D E
for the
SB-GM-C7CP1/10TW3
SKU# 94605
2014 & Up Corvette C7 Stingray
Enclosure Type:
Driver Type:
Nominal Impedance:
Continuous Power Handling:
Sealed
10TW3-D4
2 ohms
400 watts (RMS method)
INSTALLATION
DIFFICULTY:
1
OUT
OF
5
ESTIMATED TIME:
1/2 HOUR
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system.
With proper installation, your new vehicle-specific enclosed subwoofer system
will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your
authorized JL Audio dealer. The installation professionals employed by your
dealer have the necessary tools and experience to disassemble and reassemble
your vehicle properly. If you prefer to perform your own installation, please read
this installation guide completely before beginning the process.
Continued on Next Page
SB-GM-C7CP1/10TW3 INSTR_SKU# 011384
I N C L U D E D H A R D WA R E
No additional hardware required.
Page 2 • JL Audio, Inc., 2014
Continued on Next Page
SB-GM-C7CP1/10TW3 INSTR_SKU# 011384
P O W E R R E C O M M E N D AT I O N
JL Audio recommends high quality amplifiers such as the JL Audio XD300/1v2. The diagram below shows the recommended crossover settings for the XD300/1v2. For a detailed description of the
amplifier settings, consult the owner’s manual for the amplifier. If another amplifier is being used, please reference this illustration and use similar settings on that amplifier.
CONNEC TIONS
Using quality power, signal, and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your Stealthbox® amplifier. Other kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used to provide signal for both
channels of the amplifier. JL Audio recommends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.
Page 3 • JL Audio, Inc., 2014
Continued on Next Page
SB-GM-C7CP1/10TW3 INSTR_SKU# 011384
STEP 1
Empty out the trunk of the vehicle.
C O N G R AT U L AT I O N S !
You have completed the installation for this model! Enjoy your new Stealthbox®!
STEP 2
Lift up the cargo floor on the driver’s side.
STEP 3
From the underside of the cargo floor, carefully
unclip and remove the storage compartment
door.
M I D/ H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 10”- Front Doors
Fits JL Audio Models: TR650-CXi, TR650-CSi, C2-650x, C2-650,
C3-650, C5-650x, C5-650, & ZR650-CSi
STEP 4
Reinstall the cargo floor. Connect speaker
cable to the terminal cup on the enclosure, and
place the Stealthbox® into position as shown.
Route the speaker cable as necessary.
Closing the cargo hatch will lock the
Stealthbox® into position.
Rear Speaker Size / Location: 6-1/2”- Side Panels
Fits JL Audio Models: TR650-CXi, TR650-CSi, C2-650x, C2-650,
C3-650, C5-650x, C5-650, & ZR650-CSi
How we play.™
(954) 443-1100
w w w. j l a u d i o . c o m
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, and “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc.,. “Ahead of the
Curve”, its respective logo, and “How we play” are trademarks of JL Audio, Inc.,.
Printed in USA • ©2014 JL Audio, Inc.,. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431
#6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending. For more detailed information please visit us online at www.jlaudio.com.
JLA-SKU# 011384 • ver. 08.05.2016 • 10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
Page 4 • JL Audio, Inc., 2014

Similar documents

SB-GM-CTRIP/10TW3

SB-GM-CTRIP/10TW3 instructions. Failure to mount the enclosure properly presents two problems: 1) The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s...

More information

SB-LR-4/10TW3

SB-LR-4/10TW3 enclosure caused by the force exerted by the woofer(s). 2) A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

More information

SB-J-WRUD/10TW1

SB-J-WRUD/10TW1 enclosure caused by the force exerted by the woofer(s). 2) A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

More information

SB-MIN-COOP/8W7

SB-MIN-COOP/8W7 SB-MIN-COOP/8W7 INSTR_SKU# 011280

More information