cheek riser instructions

TAC PRO® CHEEK RISER FOR M14 RIFLE
Installation instructions
1. Place riser on stock as shown above.
Rear of riser should be 1.75” from end of
stock and the two dimples at top of riser
should be contacting top of stock.
2. Clamp riser to stock as shown above.
3. Place tip of .25” drill bit against upper
inside edge of slot as shown. Carefully drill
HALF WAY through stock. Repeat with
remaining 3 slots.
4. Remove riser from stock. From left side of
stock, insert drill bit into holes that were drilled
in step 3. and connect each pair of holes by
drilling completely through the stock.
5. After completing step 4., place riser back
on stock and insert carriage bolts through
riser and stock from left to right. Screw locking
knobs onto bolts and adjust riser to desired
height before tightening knobs
.
©2009 TAC PRO Inc. 1136 Centre St., Suite 428, Thornhill, Ontario, L4J 3M8 phone: 905 738-4711