Uitnodiging voor een verjaardagsfeestje

Uitnodiging voor
een
verjaardagsfeestje
01
Inspiration: 12198
02
Cut out the dress, the collar
and the petticoat from the
template in matching colours.
03
Assemble the parts with
double-sided adhesive tape
and 3D foam pads.
04
Attach a ribbon around the
waist of the dress and fasten it
on the back. For the bow, cut a
piece of ribbon measuring
approx. 20cm, tie the bow and
attach it to the belt with a 3D
foam pad. Trim the ends.
Decorate the small collar with
self-adhesive rhinestone
half-pearls.
Uitnodiging voor een
verjaardagsfeestje
07
05
Make a small border and
attach it to the card with
double-sided adhesive tape.
09
Cut a piece of silver-plated
wire for the hanger. Double
over the wire and twist a
couple of times and form it.
Bend the ends to form a small
loop.
06
Attach the dress to the hanger
with 3D foam pads. Use two
3D foam pads on top of each
other to achieve the same
height as the hanger.
For the bead coil, cut a piece
of wire measuring 20cm. Pull
beads onto the wire and twist
the wire around a darning
needle.
10
Push a hole through the card
and attach the bead coil.
11
De uitnodiging en de decoratie zijn gemaakt van
papier en kralen. De kleine hanger is gemaakt
van verzilverd draad en past uitstekend bij de
kleine jurk.
Attach the hanger onto the
card. Attach 3D foam pads and
attach the hanger with another
two 3D foam pads.
08
Cut a piece of paper. Attach
the paper over the wire ends
on the back with double-sided
adhesive tape.
12
13
14
Place Cards:
Cut a piece
of silver-plated wire measuring
25cm. Twist to form a small
loop at the end. Pull seven red
and seventy orange beads
onto the wire.
15
19
Bend the flower head around
the silver-plated wire.
16
Form the petals and close the
flower.
17
Twist the wire around the
leaves.
21
Pull a bead onto the end of the
silver-plated wire.
18
Cut a new piece of
silver-plated wire and twist it
around the stalk.
20
Pull a bead onto the end of the
wire and bend to form a coil.
22
Bend to form a hook for
hanging onto the glass.
23
Form the leaves.
25
Bend the wire to a suitable
size. Feed the wire through
the middle of the flower.
Twist the wire around the ring.
The finished napkin ring.
Patroon
27
Cut a piece of card for the
place card which is attached
onto the flower stalk with
double-sided adhesive tape.
24
A place card.
26
A Napkin Ring:
Make a
flower following the same
procedure as for the place
card. Feed a 30cm long piece
of wire through the middle of
the flower, double over and
twist.
Kaarten &
Enveloppen,
afmeting kaart
10,5x15 cm,
afmeting envelop
11,5x16,5 cm, rood,
10sets
23714
Kaarten &
Enveloppen
23718
Gekleurd Karton,
A4 210x297 mm,
180 gr, mandarijn,
20vellen
21113
Vivi Gade Design
papier, vel
30,5x30,5 cm, 120
cm, London 3,
5vellen
25503
Verzilverd draad,
dikte 0,6 mm, 10m
61006
Geruit lint, b: 6 mm,
rood/wit, 5m
513850
Geruit lint, b: 6 mm,
antiek rood/crème,
5m
513860
Rocailles, d: 3 mm,
gatgrootte 0,6-1,0
mm, oranje, 25gr,
afm 8/0
682021
Rocailles, d: 3 mm,
gatgrootte 0,6-1,0
mm, donkerrood,
25gr, afm 8/0
682031
Halve parels, afm
2-8 mm, rood,
Copenhagen,
140assorti
28319
3D foam pads, afm
5x5x1 mm, 10
vellen
24697
Dubbelzijdig
klevend tape, b: 6
mm, 10m
24633
Dubbelzijdig
klevend tape, b: 6
mm, 6x50 m
24651
Kniptang, 1stuk
13010
Verzilverd draad,
100 gr, dikte 0,6 gr,
verzilverd, 40m
61022